logo commercial door repair ontario
Serving All GTA Toronto area, For any Commercial Doors, Garage Doors, Steel Doors, Aluminum Doors, Metal Doors, Wood Doors, Fire rated Doors, Glass Doors, Doors Hardware, Door Hinges, Door Closer, Exit Bar Doors, Door Locks.

COMMERCIAL DOOR REPAIR ONTARIO

Emergency Door Repair Call 24/7

Storefront Door Repair in Toronto

Aluminum and glass storefront doors repaired the same day: dragging doors, broken pivots, failed closers, locks that will not throw and cracked glass. Serving retail, restaurants, clinics and plazas across Toronto and the GTA.

✓ 24/7 emergency service✓ Licensed & insured technicians✓ Toronto & the GTA✓ Commercial doors only

Toronto storefront doors take a beating

A busy storefront door can open and close well over a thousand times on a good day. Add Toronto winters, salt on the floor, delivery carts and the occasional bump from a vehicle, and it is no surprise that the front door is the most-repaired door in most retail buildings. When it fails, it fails at the worst moment: at opening, at closing, or in the middle of a rush.

Commercial Door Repair Ontario repairs aluminum storefront doors and frames, all-glass entrances and the hardware that makes them work. We fix the door you have whenever that is the smart choice, and we tell you honestly when replacement makes more sense.

Storefront Door Repair Toronto - Commercial Door Repair Ontario
Storefront Door Repair Toronto | Call 647-931-0097

Storefront door problems we fix every day

Most storefront calls fall into a handful of problems. Each has a clear cause and a clear fix.

Door dragging or scraping the floor

Almost always a worn bottom pivot or a floor closer spindle that has dropped. The door sinks on the latch side and rubs the threshold. We replace the pivot or closer and re-hang the door square.

Door will not lock at closing time

When the door drops, the hook bolt misses the strike. We realign the door, adjust or replace the strike and service the cylinder so the lock throws cleanly every night.

Door slams or will not close

A leaking closer cannot control the door. We repair or replace surface, overhead concealed and floor closers and set the closing and latch speeds properly. See commercial door closer repair.

Broken pivots and offset arms

Top and bottom pivots, intermediate pivots and offset arms wear out on heavy aluminum doors. A broken pivot can let the door fall, so we treat it as urgent.

Cracked or shattered glass

We board up the opening the same day if needed, then replace the glass. Tempered or laminated glass is matched to what the door requires. See glass repair and replacement.

Bent frames and stiles

Forced entry, carts and vehicles bend aluminum. Minor bends can be corrected; severe damage means a new stile, frame section or door.

Aluminum storefront door repair, step by step

A proper storefront repair is about the whole opening, not one part. This is how our technicians approach every job.

1. Diagnose the real cause

We check how the door hangs, how it closes, how the lock meets the strike and how the frame sits in the opening. A lock that will not throw is often a pivot problem, and a slamming door can be a closer and an arm at the same time.

2. Secure the opening if needed

If the door cannot be locked or the glass is broken, we secure the store first. Our emergency door repair team handles board-ups and temporary locking.

3. Repair or replace the failed parts

Pivots and hinges

Offset and centre-hung pivots, intermediate pivots and continuous hinges. Many older storefronts in Toronto still have pivots that are decades old. For hinge-hung doors see storefront hinge door replacement in Toronto.

Closers

Surface closers, overhead concealed closers in the header and floor closers in the slab.

Locks and exit hardware

Narrow-stile deadlocks, deadlatches, cylinders, push bars and panic bars and exit devices.

4. Adjust, test and hand over

We set the door square, adjust the closer, and test locking and latching repeatedly from both sides before we leave.

Commercial pivot door repair on an aluminum storefront
Commercial pivot door repair on an aluminum storefront

Repair or replace your storefront door?

Most storefront doors can be repaired. These are the signs we use to recommend one or the other.

SituationUsually repairConsider replacement
Door drags or sagsWorn pivot or hinge, door otherwise straightStiles bent or corners separating
Lock problemsAlignment, strike, cylinder or lock bodyStile crushed around the lock pocket
Closer problemsAdjustment or new closerFrame cannot support a closer properly
Glass damageGlass replacement in a sound frameFrame bent along with the glass
Age and draftsNew weatherstripping and sweepRepeated repairs every season

If replacement is the better option, see commercial door replacement and commercial door installation.

Storefront door care for Toronto businesses

A few habits keep storefront doors working through the year:

  • Keep salt, grit and ice off the threshold and floor closer plate in winter
  • Do not prop the door open with wedges; it strains the closer and pivots
  • Report dragging, slamming or a lock that needs a push right away
  • Check that the door closes and latches from fully open, not halfway
  • Book a door inspection before winter and before busy seasons

Accessible entrances also need to keep working for everyone. Ontario’s accessibility rules for businesses explain the general requirements; we repair and install automatic door operators to keep entrances usable.

Storefront door won’t lock tonight? Call now.

📞 647-931-0097

Who we work with

We repair storefront doors for independent shops, restaurants and cafés, pharmacies and clinics, salons, banks, plazas and strip malls, office lobbies and condo commercial units. Property managers use us for multi-unit plazas where several entrances need service on the same visit.

Plazas and property managers

We can inspect every entrance on a property, give a written list of issues, and repair them in one scheduled visit to keep disruption low.

Restaurants and food service

Front doors and rear service doors in restaurants see grease, moisture and constant use. We service both, including the steel back door that is often neglected.

Quick aluminum door repair for a Toronto business
Quick aluminum door repair for a Toronto business

Storefront door hardware we repair and replace

Storefront doors look simple from the outside, but each one is a system of parts that have to work together. These are the components we service most often on Toronto storefronts.

Offset and centre-hung pivots

Pivots carry the weight of the door at the top and bottom. Offset pivots sit just off the frame; centre-hung pivots sit in the middle of the door thickness and are common on all-glass and older aluminum entrances. Worn pivots are the number one cause of dragging and misaligned doors.

Continuous geared hinges

Many property owners convert worn pivots to a full-height continuous hinge. It spreads the load along the whole edge of the door and stands up well to heavy traffic and wind.

Narrow-stile locks and deadlatches

The lock body sits inside a stile only a few centimetres wide. We replace hook-bolt deadlocks, deadlatches, cylinders, thumbturns and strikes, and key new cylinders to match your existing keys where possible.

Push bars, pulls and panic devices

Pull handles loosen, push bars bend, and exit devices stop latching. On required exits we fit hardware that releases with one motion and relatches every time.

Closers of every type

Surface closers on the frame, overhead concealed closers inside the header and floor closers in the slab. Each fails differently, and each has its own repair or replacement path.

Weatherstripping, sweeps and thresholds

Worn seals let in drafts, rain and snow. Replacing brush or vinyl weatherstripping and the bottom sweep is a quick improvement before winter.

Aluminum frames and glazing stops

The aluminum frame holds the glass in place with glazing stops and gaskets. When the gaskets shrink or the stops loosen, glass can rattle or leak. We re-set glazing, replace gaskets and correct frames that have shifted. For heavier aluminum work see our aluminum door repair services in Toronto.

What affects the cost of storefront door repair

Every storefront is different, so we quote after seeing the door. These are the main factors that move the price up or down:

The part that failed

A closer adjustment or strike alignment is a short visit. A new floor closer, a pivot set or a lock body takes more time and parts. Glass replacement depends on the size and type of glass.

The age and make of the door

Common parts for popular storefront systems are easy to source. Older or discontinued systems may need adapted parts or a conversion, for example from pivots to a continuous hinge.

Urgency and timing

After-hours emergency calls and board-ups cost more than scheduled repairs. Booking a repair as soon as the door starts to drag or slam usually keeps the job small.

How many doors

Plazas and buildings with several entrances save time and travel when all the doors are serviced on the same visit.

Ask us for a written quote before any work. Call 647-931-0097 or send a request.

Aluminum glass storefront door replacement
Aluminum glass storefront door replacement

Storefront door repair FAQ

How fast can you come for a storefront door that will not lock?

We offer same-day and 24/7 emergency service across Toronto and the GTA. Arrival time depends on location and current calls; we give you an honest estimate when you call.

Why is my storefront door dragging on the floor?

The bottom pivot or floor closer spindle is usually worn, so the door has dropped. Replacing the worn part and re-hanging the door fixes it.

Can you repair the door without replacing the glass?

Yes. Pivots, closers, locks and frames are repaired independently of the glass in most storefront doors.

Do you work on all-glass (frameless) doors?

Yes, including patch fittings, floor closers and top pivots on tempered glass entrances.

Can you match my existing keys?

In most cases we can service or rekey the existing cylinder or key a new one to match.

Do you give a quote before starting?

Yes. We explain the options and the cost before any work begins. Call 647-931-0097 or request a quote online.

Storefront door stuck open or won’t lock? We can come today.

📞 Call 647-931-0097